A couple of years ago I got some tipped scrapers in a job lot, and they hold an edge much better than HSS, much, much better.
I assumed they were tipped with Stellite or Tantung. See first pic.IMG_20150924_103453.jpgIMG_20150924_100306.jpg
So I looked around, the only supplier in AU I could find wanted $100 for a 150mm piece :o but I found used metal cutoff blades in USA stamped
VR/Wesson Tantung "G" I thought I'd make a couple of bigger scrapers from one piece and sell the other two in the Market Place here.
I'm assuming I just silversolder bits on the end of big chunks of mild steel. Any advice, has anyone done this ? Cheers Phil
I assumed they were tipped with Stellite or Tantung. See first pic.IMG_20150924_103453.jpgIMG_20150924_100306.jpg
So I looked around, the only supplier in AU I could find wanted $100 for a 150mm piece :o but I found used metal cutoff blades in USA stamped
VR/Wesson Tantung "G" I thought I'd make a couple of bigger scrapers from one piece and sell the other two in the Market Place here.
I'm assuming I just silversolder bits on the end of big chunks of mild steel. Any advice, has anyone done this ? Cheers Phil
0 commentaires:
Enregistrer un commentaire