Hi all.
After a bit of an absence from the forum and turning, I'm back into it. The poor lathe gathered dust for 5 months while I worked on some commissions and illness.....
Annnnyway, I've done heaps of turning in the past, but one skill that has eluded me is getting a clean parting off for both ends on spindle work.
I was hoping somebody could point me to a good resource in order to learn to do it properly.
Many thanks in advance.
(damn I love turning. Did it all day today and it's wonderful)
After a bit of an absence from the forum and turning, I'm back into it. The poor lathe gathered dust for 5 months while I worked on some commissions and illness.....
Annnnyway, I've done heaps of turning in the past, but one skill that has eluded me is getting a clean parting off for both ends on spindle work.
I was hoping somebody could point me to a good resource in order to learn to do it properly.
Many thanks in advance.
(damn I love turning. Did it all day today and it's wonderful)
0 commentaires:
Enregistrer un commentaire