Not quite sure what to do here - the screw is snapped off just below the surface - diamater is 2.7mm x 25mm long - too big for the stewmac doo hickie - blue tape marks the back of the bridge - is there a way to retrieve it or am I wasting my time ?
Fitted quite a few of these bridges and never had this happen before - Had a test string up prior to finishing and on removing the bridge got 3 out out 4 you can see on the left protested but yielded in the end and 5 snapped off as soon as pressure applied. Screws seem to be smaller and softer than previously and I remember them going in pretty tight. The timber is myrtle and pretty hard and dense.
0 commentaires:
Enregistrer un commentaire