I bought a Carbatec 6 inch jointer today from the Canberra wood show to save on the freight as its very heavy unit. It was their display model but everything looked in fine condition.
I've got it home and am now looking at it and am really confused by its set up. I don't have a manual so I can't cross check that everything is how it should be but assume it would be if its their display model and set up by them.
On the unit is this power unit and switch with these two power cords coming out, one ends in a a wall plug and the other ends in a kettle lead, as shown in the photos below:
IMG_0177.JPGIMG_0179.JPG
Then inside the enclosed stand there is the motor with another power pack with another wall plug and a cord that plugs directly into the motor.
IMG_0180.JPGIMG_0182.JPG
There is nowhere i can see that I can plug the kettle lead into, and can't for the life of me figure out why there is two wall plugs and two power switches.
If anyone could shed some light for me, that would be great!
I've got it home and am now looking at it and am really confused by its set up. I don't have a manual so I can't cross check that everything is how it should be but assume it would be if its their display model and set up by them.
On the unit is this power unit and switch with these two power cords coming out, one ends in a a wall plug and the other ends in a kettle lead, as shown in the photos below:
IMG_0177.JPGIMG_0179.JPG
Then inside the enclosed stand there is the motor with another power pack with another wall plug and a cord that plugs directly into the motor.
IMG_0180.JPGIMG_0182.JPG
There is nowhere i can see that I can plug the kettle lead into, and can't for the life of me figure out why there is two wall plugs and two power switches.
If anyone could shed some light for me, that would be great!
Confused by new Carbatec Jointer
0 commentaires:
Enregistrer un commentaire