Hi guys
Just thought I'd see if any one here has a tapered reamer to ream a hole out that is 3/8" all the way through and if possible a tapered pin to suit whilst I have crane off the truck, otherwise I'll have buy a reamer.
Gearshift on the Acco is getting sloppy, it originally had a 5/16" taper pin in it but was drilled to suit an 8mm bolt 3 or 4 years ago and that has now worn the hole through the shaft to the point that gear changes are sloppy again.
So hole is currently 3/8" to get past the wear but should be reamed to fit a taper pin rather than a bolt, hence my request for help.
I do have experience with tapered reamers from my coppersmith years and I am prepared to pay for hire of reamer and tapered pin if you have one available.
Pics of crane off the the old girl on the newer truck and of where the pin needs to go, currently has a 3/8" bolt in shaft.
Just thought I'd see if any one here has a tapered reamer to ream a hole out that is 3/8" all the way through and if possible a tapered pin to suit whilst I have crane off the truck, otherwise I'll have buy a reamer.
Gearshift on the Acco is getting sloppy, it originally had a 5/16" taper pin in it but was drilled to suit an 8mm bolt 3 or 4 years ago and that has now worn the hole through the shaft to the point that gear changes are sloppy again.
So hole is currently 3/8" to get past the wear but should be reamed to fit a taper pin rather than a bolt, hence my request for help.
I do have experience with tapered reamers from my coppersmith years and I am prepared to pay for hire of reamer and tapered pin if you have one available.
Pics of crane off the the old girl on the newer truck and of where the pin needs to go, currently has a 3/8" bolt in shaft.
0 commentaires:
Enregistrer un commentaire