How difficult is it to cut a thread on the end of a stainless steel rod?
Will a regular set of dies, P&N or Chinese survive it or will it blunt the die?
Following "Anorak Bob" I was considering changing some of the bars on machine handles to stainless.
1st Dec 2014, 03:20 PM
Will a regular set of dies, P&N or Chinese survive it or will it blunt the die?
Following "Anorak Bob" I was considering changing some of the bars on machine handles to stainless.
1st Dec 2014, 03:20 PM
0 commentaires:
Enregistrer un commentaire