Not a new shed yet, still waiting on development approval, but hopefully it wont be too far away.
This is the basic layout. Size was restricted by the size of my block. The rear street is the only vehicle access to the block, so I needed to leave room for a car to get through to the garage which is in the rear lower level of the house.
On advice from the certifiers, to speed up DA it was decided to set the shed back 1.5m off the rear boundary. I am going to construct a 6' block wall fence on the rear boundary. This gives me a great little space to fit a DC and a timber storage area. I will put a small roof over the space once the shed is all approved and signed off.
Based on advice from people here, doors are at the opposite end of the shed from where I intend to put the DC. I will seal up the shed as well ( I have a heap of expired sikaflex sausages here that still work!!!).
So the big question, what DC should I buy? My current single bag carbatec 2hp model is pretty much only good for removing chips so it needs to be upgraded. Single phase prefered, but I am wiring the shed for future 3phase upgrade. If 3 phase is quieter, then I will go down that path.
Thanks.
This is the basic layout. Size was restricted by the size of my block. The rear street is the only vehicle access to the block, so I needed to leave room for a car to get through to the garage which is in the rear lower level of the house.
On advice from the certifiers, to speed up DA it was decided to set the shed back 1.5m off the rear boundary. I am going to construct a 6' block wall fence on the rear boundary. This gives me a great little space to fit a DC and a timber storage area. I will put a small roof over the space once the shed is all approved and signed off.
Based on advice from people here, doors are at the opposite end of the shed from where I intend to put the DC. I will seal up the shed as well ( I have a heap of expired sikaflex sausages here that still work!!!).
So the big question, what DC should I buy? My current single bag carbatec 2hp model is pretty much only good for removing chips so it needs to be upgraded. Single phase prefered, but I am wiring the shed for future 3phase upgrade. If 3 phase is quieter, then I will go down that path.
Thanks.
0 commentaires:
Enregistrer un commentaire