Hi there, could someone point me in the right direction.
I have just made a square tabletop roughly 1.7 x 1.7 made from 3 slabs of Lemon scented gumtree.
I have been advised so many different finishes ( at Wood show wa) and is confused..
I was initailly thinking of a wipe on poly that I made myself with polyeurathane, mineral turpantane and a tiny bit of linseed oil.
At the wood show I was told it would probably be best if I use penetrol and saturate it.
The Flood Company Australia » Wood Care Products » penetrol_wood_oil
On a side note, I was wondering if it would be ok if I wipe on some epoxy (west system) to seal all the gaps/knots/defects and then sand it all down and then use either the oil/wipe on poly to finish it.
Any help would be greatly appreciated.
Regards
I have just made a square tabletop roughly 1.7 x 1.7 made from 3 slabs of Lemon scented gumtree.
I have been advised so many different finishes ( at Wood show wa) and is confused..
I was initailly thinking of a wipe on poly that I made myself with polyeurathane, mineral turpantane and a tiny bit of linseed oil.
At the wood show I was told it would probably be best if I use penetrol and saturate it.
The Flood Company Australia » Wood Care Products » penetrol_wood_oil
On a side note, I was wondering if it would be ok if I wipe on some epoxy (west system) to seal all the gaps/knots/defects and then sand it all down and then use either the oil/wipe on poly to finish it.
Any help would be greatly appreciated.
Regards
0 commentaires:
Enregistrer un commentaire